Product Description
Prepare to elevate your audio experience to new heights with the DOWN4SOUND JP93 TEAL Monoblock Amplifier. Engineered to be the best of the best with cutting-edge technology and unparalleled performance, this amplifier delivers an incredible sound experience.
Key Features:
Power Ratings:
1 ohm RMS Power: 9300W x 1
2 ohm RMS Power: 7100W x 1
4 ohm RMS Power: 4400W x 1
Strapped Power: 18600W x 1
Frequency Response: 14Hz – 263Hz
Low Pass Filter: 35Hz – 250Hz
Subsonic Filter: 10Hz – 50Hz
Phase: 0º - 180º
Bass Boost: 0 - 9dB
Bass Frequency: 20Hz - 80Hz
Input Sensitivity: 6V - 0.2V
Signal to Noise Ratio: 91dB <
Total Harmonic Distortion: Less than 0.1%
Operating Voltage: 12V - 15.5V
3 x 0 Gauge Power/Ground Terminals
Fusing: 1000A Total single | strapped 2000A
Dimensions: 28.34" L x 9.37" W x 2.71" H
Supports up to 4 Gauge Speaker Wire
STRAPPABLE DIGITAL MONOBLOCK AMPLIFIER
STABLE INTO 1 OHM MONO LOAD
HIGH SPEED MOSFET POWER SUPPLY
VARIABLE LOW PASS FILTER
VARIABLE SUBSONIC FILTER
VARIABLE BASS BOOST & BASS FREQUENCY
4 WAY PROTECTION CIRCUITS (THERMAL, HIGH & LOW VOLTAGE, SPEAKER SHORT AND DC)
BLUETOOTH REMOTE CONTROL (REMOTE BASS KNOB WITH VOLTMETER, AMPLIFIER TEMPERATURE AND CLIPPING INDICATOR)
HIGH PURITY COPPER PRINTED CIRCUIT BOARD
Power up and experience bass like never before with the DOWN4SOUND JP93 TEAL Monoblock Amplifier. Engineered to be the best of the best with cutting-edge technology and unparalleled performance, this amplifier delivers an incredible sound experience
Your new Down4Sound product is covered by 1 limited warranty if purchased from Down4Sound or an authorized Down4Sound dealer. This warranty does not cover improper installation, accidental damage, misuse, abuse, improper wiring, operation of unit outside of listed specifications, or any product that has been modified or repaired by anyone other than Down4Sound. Your warranty covers defects in materials and/or workmanship ONLY and is not an insurance policy. The warranty only covers the original owner of the amplifier.
All warranty returns must be accompanied by the original sales invoice or receipt. You must contact us to request an RMA number prior to sending any returns via the RMA request form on our website. You are responsible for the cost of shipping your product back to us for warranty examination. If your product is covered under warranty, shipping back to you will be at no charge to you – if your product is replaced/repaired outside of warranty you must pay for return shipping and repair bill prior returning of the product or if no defect is found you are required to pay for return shipping only.
At the sole discretion of Down4Sound your product will be either repaired or replaced when it is being covered under warranty. In the event of shipping damage due to improper packaging on products being returned to Down4Sound the customer is liable for the cost of all damages, necessary repairs, or replacement. Be sure to properly pack your return!
* Extended additional warranty purchased on amplifiers take in affect from the date of purchase and must also be stated on orginal sales invoice or receipt.
